+8613831176073    :  emily@jhlasertube.com 
Home » News » Blog » Precautions during the use of Jing Hang glass co2 laser tube and znse laser lens and laser mirror

Precautions during the use of Jing Hang glass co2 laser tube and znse laser lens and laser mirror

Views:2     Author:Site Editor     Publish Time: 2019-10-15      Origin:Site


 1. Jing Hang glass co2 laser tube installation fulcrum should be reasonable, the fulcrum should be at 1/4 of the total length of the co2 laser tube,co2 laser tube wall has identification, otherwise the co2 laser tube spot pattern will be deteriorated. Some working spots will become several points for a period of time, causing the laser power to drop to meet the requirements, resulting in Constantly change the tube, carefully read the "Notes on the use of co2 laser tube."

 2. The cooling system should be grounded, and the water tank and waterway should be cleaned frequently. The temperature control point of the cooling temperature control water tank should be reasonable. Otherwise, the co2 laser tube will be easily damaged and the dew condensation power will drop, the cold head of the tube will fall off, the service life will be shortened, and sometimes it will not work. Constantly changing the tube.

 3. Water protection should be checked and cleaned frequently. Cooling water can not be washed out. Water protection float switch or water protection float switch is not reset. Short-circuit method cannot be used to solve the urgent need. The cooling water quality should be good. The aluminum oxide of the nozzle is too serious. It should be cleaned regularly for the water in the water pump and the water pipe and the water protection. Otherwise, the co2 laser tube will burst or the cold head will fall off.

 4. The suction device should be regularly inspected and cleaned, and the fan duct should be cleaned up. Otherwise, a lot of smoke and dust will not be discharged, and the znse laser lens and the co2 laser tube will be seriously and quickly contaminated, so that the mechanical and electronic components are easily oxidized and the contact is not good.

 5. Focusing laser mirror and mirror inspection, the frame will heat up after a while, the surface of the znse laser lens will be discolored and rusted; the film cracking is the object to be replaced, especially for many customers using atmospheric pump and air compressor, so that the focusing laser lens Water accumulates quickly, so it is necessary to check the cleaning and quality of the optical system of the znse laser lens (co2 laser tube exit) on time.


PRODUCT INQUIRE

DO BEST LASER TUBE MANUFACUTER

Home

Copyright © 2018 Shijiazhuang Jinghang Laser Technology Co., Ltd.     
 Support By Rongchuangmedia