Views:7 Author:Site Editor Publish Time: 2019-11-29 Origin:Site
The installation procedure of the 80w co2 laser tube is very simple, but it is not easy to strictly operate, especially the second-hand laser engraving machine. There is no uniform standard for the co2 laser tube support position of the laser engraving machine manufacturer. At the same time, the manufacturer of the CO2 laser tube has no uniform standard for the pointing position of the co2 laser tube, so it is a bit messy, but the rules still need to be clearly stated. This is a principle problem.
The installation steps of the 80w co2 laser tube are as follows:
1. First, the support position of the laser engraving machine and the position of the fulcrum of the co2 laser tube should be consistent. It is better to change the support position of the laser engraving machine.
2. The Co2 laser tube cannot be placed horizontally during installation. It should be that the light exit of the co2 laser tube is 2 mm higher than the high pressure, so that the water of the co2 laser tube can be safely discharged.
3. The wires of the Co2 laser tube and the wires of the laser power source are insulated to prevent ignition.